TLS LocksmithsCamborne, Cornwall

Multipoint locks: matched, measured, replaced

A multipoint lock bolts the door at several points. When its gearbox fails, Tony measures the old one, matches it and fits a replacement so the door locks properly again.

A multipoint lock gearbox with a yellow tape measure laid along it
Measuring a gearbox to match a replacement
  1. 1Tape measure along the faceplate
  2. 2Cut-out for the cylinder
  3. 3The gearbox case
Subject
Multipoint locks
Series
Services

What a multipoint lock is

Most modern front and patio doors do not use a single bolt. A long strip, the faceplate, runs down the edge of the door with a gearbox in the middle. When you lift the handle and turn the key, hooks, bolts or rollers move out at several points and pull the door tight into the frame.

That is why a multipoint lock is secure and also why it can fail in many ways: the gearbox wears, a bolt sticks, the handle spindle goes, or the door drops so the bolts miss their keeps.

How Tony matches a replacement

He measures the old gearbox with a tape before ordering. The measurements that decide whether a replacement fits are the distance from the edge of the faceplate to the centre of the keyhole (the backset), the distance between the keyhole and the handle spindle (the centres), and the overall length of the strip. In the photos on Tony's Google profile you can see him doing exactly this.

Getting those numbers right is what makes the new lock fit first time. A reviewer wrote of a fault with "the necessary part" ordered, then "returned and finished the job".

Signs yours is failing

The handle feels loose, sticks or does not spring back. The key is stiff to turn. You have to lift the handle hard or slam the door to lock it. The door locks only some days. If you see any of these, ring early: a failed gearbox can lock you in or out.

Repair, adjust or replace

Sometimes a door just needs adjusting. Tony checks the hinges and keeps first so you do not pay for a gearbox the door did not need. See how to tell if your multipoint lock is failing.

Questions about this

What do you need to know to replace my multipoint lock?

Ideally a photo of the door edge, but Tony usually measures the old gearbox on site. He then orders the match, or fits one from stock if he has it.

Why will my door only lock if I slam it?

The most common causes are a worn gearbox or a door that has dropped. Tony checks both.

Can you replace the cylinder only?

Yes. If the gearbox is fine, replacing the euro cylinder is a smaller, cheaper job.

Is it worth replacing a multipoint lock on an old door?

Usually, if the door is otherwise sound. A new gearbox costs far less than a new door.

Call TonyWhatsAppText